So running the calibration tool is pretty easy, just follow the included directions but note, on a dual monitor setup run it on your primary monitor first. The one marked “1” in the display settings. After the tool completes its going to install an application that runs on startup and makes sure the correct profile is loaded. This profile will be put in the directory I stated above. Now after this is done, go into that directory and rename the profile. I renamed mine from Spyder2Express.icm to Spyder2Express_right.icm and when I do the left monitor I will rename that one ‘_left’.

After this you’ll want to take your monitors and switch the primary monitor to your secondary. This way you can run the software on the other monitor now. Restart the machine and once the new primary monitor is set run the Spyder2Express again. This profile will be in that same directory with the default name again. Rename this one to something, i.e. “_left”. And you’re done with the calibration tool.

Now after this I go into our color control software, be it Vista’s built in software or our downloaded applet for XP, and I select one of the monitors listed (if you have different makes and models this will be easy, if they are the same it’s a bit of guesswork) and associate it with one of the profiles made, either the _right or the _left profile. Now select the other monitor and associate with the other profile. After applying these changes restart your machine. When the Spyder2Express Software loads up you *should* see a message on each screen where it is loading up the color profile. Now in the silly case where you have two of the same monitor and the color profiles have switched ( you see the _left profile loading on the right) go back into the applet and switch the profiles.

TADA…your done ....email me or post comments on any problems/questions